How can I conceal grids while applying a wig? If the laces you're using are a little bit stiffer, you'll achieve a more established look. The higher the quality of the lace on a wig, the more effectively the fake scalp approach would work. However, it will fit on all wigs. With this method, you can part your wig anywhere without revealing any grits or lace while pulling it up. The best part about this approach is that it works on all skin tones.
Choose a 360 lace wig cap; this will fit any curly frontal lace wig. The grids of the unprocessed wig are very clear, as are the knots. This is how your wig would usually begin when you take it straight out of the box. We will transform this, and each move is critical. The first step is to turn the wig inside out and place it on a canvas head. Next, we'll remove the combs from the inside of the hat. Since leaving them in place would create an unnatural appearance. The simplest method of removing combs is to use a razor and cut directly through the fibers. This will prevent you from creating a hole in your lace. Make certain that you bleach the knots on your wig; this move is critical for the fake scalp method to function properly. Bleach the knots and leave for 30 minutes before rinsing. The following move is entirely optional. Tweeze the hairline to give it a more natural appearance. If your hairline is too thick in the front, the fake scalp technique will not be visible through all of the hair. You'll probably want to take your time to complete this; depending on your choice, it could take an hour to two to three hours. However, this move is optional; you are not required to complete it. If your wig is damp, allow it to dry completely before attempting this process. Blow-drying the hair and styling the wig on a mannequin head will aid in a quicker application, particularly if you're in a hurry the next day. Curl the wig. As long as the curls are already completed when it's time to add them to your hair, there's nothing else you need to do but put it on and go. That is the advantage of styling your wig on a mannequin as opposed to your own.
To begin, obtain some knee-highs. The fake scalp technique combined with the knee-highs is the perfect combination since they are available in a variety of colors. These knee-highs are available at any drugstore or retail location. Put the cap on the mannequin inside out and then cover the whole wig with this stocking cap. Spray a setting spray all over the hat, including the area where the hairline begins and the remainder of the cap with the lace in the center. Blow-dry it to ensure it's fully safe, and then re-spray it with another layer of setting spray. When putting on the bold stocking hat. This is almost identical to the previous process, except it is performed on the wig, which is less messy and much simpler to do. Remove any excess limit that is not needed. The advantage of adding the cap to the wig rather than your head is that you can prep your wigs prior to wearing them, which saves you a lot of time if you have several wigs. It looks fantastic and blends in well with the lace. Assemble your knee-high to match your scalp color, then apply additional setting spray to eliminate the cap's edges and blow dry it down some more. and it will be extremely stable, as it will not be moved. The only disadvantage is that your hairline will be slightly stiff, but this is not a problem; all you have to do is brush it back and avoid applying water, as water will dissolve it. Brushing the edges and styling it slightly will loosen the stiffness, so there is no need to be concerned. If the wig cap is already attached to the Malaysian hair wigs, all that is necessary is to glue it down. To eliminate one more step from your application process, take the wig glue and apply it to the front of your hair. It will blend in with your stocking cap, lace, and skin. This approach makes the wig glue feel significantly more comfortable than applying it directly to your scalp, as long as any trace of oil around your hairline is cleaned away.
